A good way to get the HP2-T11

es
T tpassportQ&A

---

The safer , easier way to help you pass any IT exams.
Exam : HP2-T11
Title
: I
n
d
ustry Standard
Architecture and Technology
Version : Demo
1 / 7

---

The safer , easier way to help you pass any IT exams.
1.Which statement best describes PCI Express architecture?
A. Data is sent in parallel
B. Data is sent serially over each link
C. PCI Express has more pins than PCI-X
D. PCI Express transfers data in half-duplex
Answer: B
2.Which statement is correct when comparing similar versions of Intel Xeon and AMD Opteron
processors'?
A. Xeon processors are optimized for parallel execution
B. Opteron processors are optimized for parallel execution
C. Opteron processors use a Northbridge that operates at core bus speed
D. Xeon processors use an integrated memory controller that operates at core processor speed
Answer: B
3.A customer asks you for information about the advantages of RAID 6 over other RAID levels What can
you recommend? (Select three)
A. Performance is equivalent to RAID 5 when reading data.
B. It is the most cost-effective of the fault-tolerant RAID solutions.
C. lt has greater faulttolerancethan RAID4, RAID 1+0, or RAID5.
D. It uses the most storage capacity for fault tolerance of all the RAID levels.
E. it is ideal for applications requiring large logical drives with many physical drives.
Answer: ACE
4.What is a characteristic of a PCI-X-based bus?
A. You cannot use PCI-X cards in a conventional PCI system
B. It is fully backward compatible with conventional PCI devices
C. You cannot use existing PCI devices in a PCI-X-based system
D. It is compatible with conventional PCI devices only after updating to newer drivers
Answer: B
5.What is the difference between single-ended SCSI and differential SCSI?
A. Single-ended uses twisted pair wires
B. Differential is more susceptible to noise
C. Differential uses a single signal wire and has length limitations
D. Single-ended uses a single signal wire and has length limitations
Answer: D
6.Which statements apply to AMD 2P or 4P system architecture? (Select three )
A. Each processor can access only its own memory
B. Requests for memory access are handled by the Northbndge ASIC
C. Each processor can access the full complement of installed memory
D. Memory must be installed in banks corresponding to the installed processors
E. The maximum amount of memory can be installed, regardless of the number of installed processors
2 / 7

---

The safer , easier way to help you pass any IT exams.
F. Requests for memory access are handled directly by the corresponding processor and relayed through
the HyperTransport lnk
Answer: ADF
7.What is a characteristic of Double Data Rate (DDR) RAM?
A. sends data every other clock cycle
B. sends data on the rising edge of the clock cycle only
C. sends data on the falling edge of the clock cycle only
D. sends data on both the rising and falling edge of each clock cycle
Answer: D
8.What happens if you install a 66MHz, 32-bit PCI card in a 33MHz, 64-bit PCI slot? (Select two)
A. The 66MHz card operates at 33MHz
B. The 66MHz, 32-bit card operates at 33MHz in 32-bit mode
C. The 66MHz, 32-bit card operates at 33MHz in 64-bit mode
D. Any 33MHz, 64-bit cards on the PCI bus operate like 33MHz, 32-bit cards
Answer: AB
9.What is an advantage of using iSCSI?
A. it enables the use of SCSI cables for Ethernet communications
B. it enables the use of SAS and SATA drives using standard SCSI controllers
C. It overcomes the inability to use shared storage devices in a heterogeneous environment
D. It overcomes the distance limitations associated with standard Fibre Channel storage transport
Answer: A
10.In systems with AMD processors, what allows communication between processors and the I/O
subsystem?
A. APIC
B. Northbridge
C. Southbridge
D. HyperTransport lnk
Answer: D
11.A customer has an existing mission critical database application using approximately 20TB of network
storage and plans to add a web server component to the existing environment to increase the storage by
50% Which tape storage technology would you recommend?
A. Autoloader
B. Travan Tape System
C. business-class library
D. enterprise-class library
Answer: C
12.In systems with AMD processors, what allows communication between processors and the I/O
subsystem?
3 / 7

---

The safer , easier way to help you pass any IT exams.
A. APIC
B. Northbridge
C. Southbridge
D. HyperTransport lnk
Answer: D
13.How does the operation of RAID memory differ from RAID 5 disk storage? (Select three)
A. Data is written sequentially to all banks of memory
B. Data is written simultaneously to all banks of memory
C. Existing parity information must be read before calculating the new parity value
D. There is no need to read the existing parity before calculating a new parity value
E. The memory controller writes parity information to a dedicated parity bank of DIMMs
Answer: BDE
14.Which backup type would you recommend if a customer environment requires saving the latest
version of each file?
A. full
B. copy
C. differential
D. incremental
Answer: D
15.What best describes PCI-X architecture?
A. 32-bit bus that runs at speeds of up to 66MHz
B. 64-bit bus that runs at speeds of up to 66MHz
C. 64-bit bus that runs at speeds of up to 133MHz
D. 32-bit bus that runs at speeds of up to 133MHz
Answer: C
16.The system administrator typically performs a full backup every Monday and incremental backups on
Tuesdays, Wednesdays, and Thursdays In addition, full backups are performed at the end of the week
and at the end of the month
Which GFSterm refers to the monthly full backup?
A. son
B. sister
C. father
D. grandfather
Answer: D
17.Which system architecture is displayed?
4 / 7

---

The safer , easier way to help you pass any IT exams.
A. Dual Peer I/O Bus (DPIO)
B. Triple Peer I/O Bus (TPIO)
C. Highly Parallel System Architecture (HPSA)
D. Memory and I/O Controller Architecture (MIOC)
Answer: C
18.What is the maximum number of nodes supported in a Fibre Channel Switched Fabric (FC-SW)
environment?
A. 125
B. 126
C. 15 million
D. 16 million
Answer: D
19.Serial Attached SCSI (SAS) technology uses the same electrical and physical interface as which
technology?
A. IDE
B. ATA
C. iSCSI
D. SATA
Answer: D
20.Which RAID implementation allows for simultaneous failure of multiple drives?
A. RAIDO
B. RAID 4
C. RAID 5
5 / 7

---

The safer , easier way to help you pass any IT exams.
D. RAID 6
Answer: D
21.What are two major difference between SRAM and DRAM'? (Select two)
A. SRAM uses a capacitor to store a bit of data
B. DRAM uses a capacitor to store a bit of data
C. SRAM uses 4 capacitors to store a bit of data
D. DRAM uses 4 capacitors to store a bit of data
E. SRAM uses 6 to 8 transistors to store a bit of data
F. DRAM uses 6 to 8 transistors to store a bit of data
Answer: BE
22.Which statement best describes single-mode fiber when compared with multimode fibers
A. Multimode fiber has higher bandwidth and lower loss
B. Single-mode fiber has higher bandwidth and lower loss
C. Single-mode fiber has higher loss and lower bandwidth
D. Multimode fiber is more often used for long-distance telecommunications
Answer: B
23 .When planning or monitoring the storage subsystem, you must consider the RAID levels and how
they impact write and read performance Which RAID level has the greatest impact on write performance'?
A. RAIDO
B. RAID 5
C. RAID 6
D. RAID1+0
Answer:
24.Which factors help determine the business value of a server to a customer? (Select two)
A. security
B. reliability
C. RAID level
D. performance
E. operating system
Answer: BD
25.Which type of information is obtained during the site survey? (Select two)
A. customer's physical security
B. problems the customer is experiencing
C. customer's existing physical environment
D. customer expectations regarding server reliability
E. customer concerns about current or future IT problems
Answer: AC
26.Which planning and design activities are necessary to achieve a deployable solution? (Select two)
6 / 7

---

The safer , easier way to help you pass any IT exams.
A. Determine the scope of work
B. Validate, test, and document the solution
C. Establish a new baseline for future comparison
D. Identify and describe power protection and management
E. Determine if the new solution is deployable using the existing resources
Answer: AE
27.What are advantages of m-band network management? (Select two)
A. SNMP switch control
B. port or role-based VLAN assignment
C. support of host systems within a cluster
D. appropriate for wired and wireless devices
E. independent from switch/router platform and versions
Answer: AE
28.Which statements best describe m-band network management? (Select two)
A. Network ports are not used for device management
B. TELNET or SSH protocols are used to manage the devices
C. TCP/IP and SNMP protocols are used to manage the devices
D. A separate network is maintained for management access and control data
E. Control and management data share the same network as the data being processed
Answer: CE
29.Which statements regarding the installation of DIMMs are correct? (Select two)
A. ESD protection is not required
B. Performance defaults to the lower of the two speeds
C. Performance defaults to the higher of the two speeds
D. Each bank of DIMMs can contain DIMMs of mixed size and speed
E. Each bank of DIMMs must contain DIMMs of the same size and speed
Answer: BE
30.What is the percent of total disk space available when using RAID
A. 25%
B. 50%
C. 75%
D. 100%
Answer: B
7 / 7

---