actually unwanted a person , in the ual method or otherwise , you might try to keep from talking to
Page 1 of 3 Outer handle, rear door Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct. Preparatory work Disconnecting the battery lead
Disconnect the battery negative cable. See: Battery disconnecting and connecting .
Open the tailgate.
Removal Removing the outside handle rear side door Remove the cover in the end of the door.
Slacken off the screw for the lock cylinder. Note! Only loosen the screw 4 turns. Page 2 of 3 Otherwise the screw may fall down into the door. Remove: the lock bracket the rubber seal. Work the handle loose from the door.
Note! Before unplugging the connector, pull it forwards and secure in parking position (1). Otherwise the connector may fall into the door and be difficult to retrieve. Remove: the connector the handle.
Installation Installing the outside handle rear side door Install: the connector. Remove from the parking position so that it goes into the door the rubber seal the handle the lock bracket the screw for the lock cylinder. Tighten. See: Tightening torque the cover in the Page 3 of 3 end of the door. Check the function of the handle.